How do I delete all codes on Kwikset?

How do I delete the code on my Kwikset lock?

Delete A User Code:

  1. Make sure the door is open.
  2. If you have not enabled a programming code, press and release the program button. You will hear two beeps. …
  3. Press 2 to delete a user code. …
  4. Press Kwikset.
  5. Enter the user code you wish to delete. …
  6. Enter the user code again.
  7. Press Kwikset.

How do I reset my Kwikset Smart Lock?

1 Factory Reset

  1. Open your door.
  2. Extend the latch bolt.
  3. Slide up the cover to open the back of your lock, exposing the buttons beneath.
  4. Push and hold the reset button for 10 seconds, until the lock beeps.
  5. The light ring will flash red, then spin amber.
  6. The lock has now been restored and is ready to be set up again.

What is the master code for Kwikset lock?

The default Mastercode is 0-0-0-0. It is recommended that you change it to a code of your own. 1. Make sure the lock is unlocked and the door is open.

How do you remove the code on a Kwikset lock 914?

How to delete a/all user code(s) on my Smartcode touchscreen?

  1. Keep door open. Press Program button once.
  2. Press Checkmark symbol once.
  3. Press Lock symbol once.
IT IS INTERESTING:  Question: How much space should you leave around a door?

How do you reset a Kwikset 910 lock?

How to perform a factory reset:

  1. Remove the batteries.
  2. Press and hold the lock button on the keypad.
  3. Place the batteries back in (while still holding the button)
  4. The lock will beep three times over the course of 15 seconds or so. After the 3rd beep release the button.

22.08.2014

How do you open a Kwikset Smart Lock?

Unlocking from the inside of the door is done manually by turning the thumb turn. Locking and unlocking from the outside can be done automatically by an electric motor. As the last number of a correct code is pressed on the keypad, the electric motor swings into action and retracts the deadbolt.

How do I reset the master code on a Kwikset 913?

How do I program my SmartCode 913 lock?

  1. Open the door.
  2. Remove battery cover.
  3. Press the program button once.
  4. Enter new user code.
  5. Press lock button.
  6. If programming is successful the keypad will flash green once, and you will hear one beep.

How do I remove code from Kwikset SmartCode 911?

Deleting a user code In order to delete a user code, you must override the code by adding a different user code in the same position. For example, if you want to delete the third code, add a different user code in position three. NOTE: Test the old user code to make sure it can no longer unlock the door.

How do you remove the code from a keypad lock?

Deleting User Codes

  1. Press the program button.
  2. Press the lock button.
  3. Enter user code to delete.
  4. Press lock button.
  5. Re-enter user code to delete.
  6. Press lock button.
  7. If successful, the keypad will flash green once and you will hear 1 beep (if switch #3 is on).
IT IS INTERESTING:  When a man opens a car door for a woman?

24.07.2017

How do you reprogram a Kwikset lock?

How do I reset a code on my Powerbolt?

  1. Insert functioning key & turn 1/4 turn clockwise.
  2. Insert & remove the SmartKey learn tool. Remove functioning key.
  3. Insert new key & turn 1/2 turn counter-clockwise. Done. Your lock is now re-keyed! “”
 Profil Doors