How do I reprogram my Kwikset electronic deadbolt?

How do I reset my Kwikset electronic deadbolt?

A factory reset will delete all codes associated with the lock.

  1. Make sure the door is open and unlocked.
  2. Press and hold the program button for 30 seconds using the SmartKey tool or a paper clip. You will hear one long beep.
  3. Press and release the program button. You will hear one short beep.

Where is program button on Kwikset lock?

Changing the Code Step-by-Step

While the door is open, press the “Program” keypad button located on the interior side of the door. Enter a four to eight digit security code that you can easily remember on the outside electronic lock keypad.

How do you program a Kwikset Smart Lock?

How do I program my SmartCode 913 lock?

  1. Open the door.
  2. Remove battery cover.
  3. Press the program button once.
  4. Enter new user code.
  5. Press lock button.
  6. If programming is successful the keypad will flash green once, and you will hear one beep.

What is the master code for Kwikset lock?

The default Mastercode is 0-0-0-0. It is recommended that you change it to a code of your own. 1. Make sure the lock is unlocked and the door is open.

IT IS INTERESTING:  You asked: How do you take the doors off a LG refrigerator?

Why is my Kwikset lock not working?

Take the battery pack out of the unit and depress the button labeled “Program” three times if the unit doesn’t operate properly after installation or fails to open with a key. Allow ten seconds to elapse, then hold down the “Lock” button while reinstalling the battery pack.

How do I reprogram my Kwikset SmartCode 909?

How to restore default settings on my Signature Series or SmartCode Deadbolt? Perform a factory reset

  1. Remove battery pack.
  2. Press and HOLD the Program button while reinserting the battery pack. …
  3. Press the Program button once more. …
  4. Perform the door handing process again to teach the lock the orientation of the door.

How do I reset my Kwikset 910 lock code?

Press and HOLD the Program button while reinserting the battery pack. Keep holding the button for 30 seconds until the lock beeps and the status LED flashes red. Press the Program button once more. When the LED flashes green and you hear one beep, the lock has been reset.

How do you reset a Kwikset 910 lock?

How to perform a factory reset:

  1. Remove the batteries.
  2. Press and hold the lock button on the keypad.
  3. Place the batteries back in (while still holding the button)
  4. The lock will beep three times over the course of 15 seconds or so. After the 3rd beep release the button.

22.08.2014

How do you remove a code from a Kwikset lock?

  1. Keep door open. Press the Program button once. The Checkmark will flash five times and you will hear five beeps.
  2. Press Checkmark symbol once.
  3. Press Lock symbol once.
  4. Enter Mastercode.
  5. Press Lock symbol once.
  6. Enter user code to be deleted.
  7. Press Lock symbol once.
  8. Re-enter user code to be deleted.
IT IS INTERESTING:  Question: How do I lock my Andersen storm door?

How do you program a Kwikset 275 touchscreen deadbolt?

How do I change the programming code on my 275 Contemporary Deadbolt?

  1. Make sure the lock is unlocked and the door is open.
  2. Enter your Programming Code – for new installation, default is 0-0-0-0.
  3. Press enter arrow. You will hear one beep.
  4. Press 4 .
  5. Press enter arrow. You will hear one beep.
  6. Enter a new Programming Code.
 Profil Doors