How do you change the code on a Kwikset aura?

How do I change the code on my Kwikset aura lock?

How do I add/delete a user code on my Powerbolt 2?

  1. Make sure the lock is unlocked and the door is open.
  2. Enter your Mastercode – for new install, default is 0-0-0-0.
  3. Press the lock button. You will hear one beep.
  4. Press 1.
  5. Press the lock button. You will hear one beep.
  6. Enter a new User Code. …
  7. Press the lock button. …
  8. Test the code: While your door is open, lock it.

How do I manually program my Kwikset aura lock?

Check that your door is aligned properly, and perform the manual door handing step below.

  1. Open the door and extend the latch to the locked position.
  2. Remove the battery pack.
  3. Press and HOLD the Program button while reinserting the battery pack. …
  4. Press the Program button once more.

What is the master code for Kwikset lock?

The default Mastercode is 0-0-0-0. It is recommended that you change it to a code of your own. 1. Make sure the lock is unlocked and the door is open.

IT IS INTERESTING:  What type of door opens up?

How do you remove a code from a Kwikset lock?

Delete A User Code:

  1. Make sure the door is open.
  2. If you have not enabled a programming code, press and release the program button. You will hear two beeps. …
  3. Press 2 to delete a user code. …
  4. Press Kwikset.
  5. Enter the user code you wish to delete. …
  6. Enter the user code again.
  7. Press Kwikset.

How do you reset a Kwikset 910 lock?

How to perform a factory reset:

  1. Remove the batteries.
  2. Press and hold the lock button on the keypad.
  3. Place the batteries back in (while still holding the button)
  4. The lock will beep three times over the course of 15 seconds or so. After the 3rd beep release the button.

22.08.2014

How do I reset my Kwikset 910 lock code?

Press and HOLD the Program button while reinserting the battery pack. Keep holding the button for 30 seconds until the lock beeps and the status LED flashes red. Press the Program button once more. When the LED flashes green and you hear one beep, the lock has been reset.

How do I reset my Kwikset SmartCode code?

How to restore default settings on my SmartCode 955? Perform a factory reset

  1. Make sure the door is open and unlocked.
  2. Press and hold the program button for 30 seconds using the SmartKey tool or a paper clip. You will hear one long beep.
  3. Press and release the program button. You will hear one short beep.

Does the Kwikset aura lock automatically?

Yes, the auto-lock time delay can be customized using the Kwikset App within Bluetooth range Aura. The selectable time intervals are: 30 seconds, 1 minute, 3 minutes, 5 minutes, 10 minutes. Click here to view instructions.

IT IS INTERESTING:  How much are antique door knobs worth?

How many phones can be connected to Kwikset aura?

Each lock can pair with up to eight (8) smartphones at a time.

How do I reset my Weiser aura lock?

Factory Reset

2 Press and HOLD the Program button while reinserting the battery pack. Keep holding the button for 30 seconds until the lock beeps and the status LED flashes red. 3 Press the Program button once more. The LED will flash green and red, and the auto-handing process will begin.

 Profil Doors