1Navigate to the menu in the app and click Wi-Fi Adapters. 2Click the “+” in the top right corner of the page. 3Type in the programming code located on the back of your Wi-Fi Adapter. 4Then plug in your Wi-Fi Adapter within 40 feet of your Schlage Sense Smart Deadbolt.
How do I reset my Schlage WiFi adapter?
Do so by a) disconnect the battery connector, b) press and hold the outside Schlage button, and while holding the outside Schlage button, reconnect the battery connector, c) make sure that you correctly reset the lock to its factory configuration by pressing the outside Schlage button and then entering one of the two …
How do I connect my Schlage Lock to WiFi?
It’s easy to set up – plug it in within Bluetooth range of the lock (usually about 40 feet), and use the Schlage Sense app to connect the Adapter to your home Wi-Fi network. Then pair it with your lock.
Does Schlage sense connect to WiFi?
To lock and unlock your Schlage Sense Smart Deadbolt from anywhere on both Android and iPhone®, add the Schlage Sense WiFi Adapter* to your home WiFi network. The WiFi adapter is a simple wall plug-in that connects to your home WiFi signal, making it easy for you to set up.
SmartHomeDBПодписатьсяHOW-TO: Pair and Connect your Schlage Lock with a Samsung SmartThings Hub
What app for Schlage connect?
The free Schlage Home App for Apple iOS and Android lets you control and monitor your lock from anywhere using your smartphone. The app guides you through the setup process and puts complete access and control of your Schlage smart locks at your fingertips.
Can Schlage encode work without WiFi?
As you probably know, the Schlage Encode Smart Deadbolt comes equipped with a built-in Wi-Fi, meaning you can connect it to your smartphone without needing any third-party hub or Wi-Fi Bridge.
What’s the difference between Schlage sense and connect?
While they look very similar, their smart home integration is the key difference between both locks. … Schlage Sense works with HomeKit for controlling your lock using Siri. Schlage Connect is designed for Alexa and Z-Wave integration. Schlage Encode is a WiFi lock that doesn’t require a hub.
How do I change my 4 digit Schlage Lock code?
Press the “Schlage” button and the number “1” button simultaneously to add/change a new entry code. Wait for the “Schlage” button to beep and flash three times. Enter a new four-digit code, and wait for the “Schlage” button to flash and beep three times. Re-enter the same four-digit code to confirm the change.
How do I control my Schlage connection from my phone?
To pair your Schlage Connect Smart Deadbolt with Samsung SmartThings, open the SmartThings app on your mobile device and tap on Home. Under Things, choose Add a Thing and follow the directions in the app. At the end of enrollment, a green light on your lock indicates success.
Do you need a hub to use Schlage connect?
Because the Schlage Connect is powered by Z-wave, you need to pair it with a smart home hub, like Wink, to extend communication with your home’s wi-fi. This allows you to communicate with your lock via the Wink app when you are remote.
How do I pair my Schlage Lock with Hubitat?
- From the Hubitat Web Interface home page, select Z-Wave, then Start Z-Wave Pairing on the Device Discovery page.
- Press the Schlage button.
- Enter the 6 digit programming code.
- Press 0.
- A √ indicates the lock successfully joined the Z-Wave network, while an X indicates that it did not successfully join the network.