How do I reset my Schlage Z-Wave lock?
Complete the following steps to factory default your Schlage Z-Wave Lock:
- Remove the battery cover. Remove the battery cover from the front of the lock. …
- Cut device power. Remove the battery from the device. …
- Perform the reset. Press and hold the Schlage button on the front of the lock. …
- Confirm the reset.
How do I connect my phone to Schlage?
It’s easy to set up – plug it in within Bluetooth range of the lock (usually about 40 feet), and use the Schlage Sense app to connect the Adapter to your home Wi-Fi network. Then pair it with your lock.
How do I pair my Schlage Lock with my wireless adapter?
1Navigate to the menu in the app and click Wi-Fi Adapters. 2Click the “+” in the top right corner of the page. 3Type in the programming code located on the back of your Wi-Fi Adapter. 4Then plug in your Wi-Fi Adapter within 40 feet of your Schlage Sense Smart Deadbolt.
How do you reset a Schlage door lock without code?
So first how to Reset Schlage Keypad lock?
- Disconnect the batteries.
- Press and hold the Outside Schlage Button.
- While holding the Outside Schlage Button, Reconnect the batteries.
- Release the Outside Schlage Button.
- To check that the lock was reset, press the Outside Schlage Button and enter one of the Default User.
How do I change my 4 digit Schlage Lock code?
Press the “Schlage” button and the number “1” button simultaneously to add/change a new entry code. Wait for the “Schlage” button to beep and flash three times. Enter a new four-digit code, and wait for the “Schlage” button to flash and beep three times. Re-enter the same four-digit code to confirm the change.
Does Schlage connect work with WiFi?
To lock and unlock your Schlage Sense Smart Deadbolt from anywhere on both Android and iPhone®, add the Schlage Sense WiFi Adapter* to your home WiFi network. The WiFi adapter is a simple wall plug-in that connects to your home WiFi signal, making it easy for you to set up.
What app do I use for Schlage connect?
The free Schlage Home App for Apple iOS and Android lets you control and monitor your lock from anywhere using your smartphone. The app guides you through the setup process and puts complete access and control of your Schlage smart locks at your fingertips.
What app works with Schlage connect?
The free Schlage Home app for Apple iOS and Android is your “remote control” if you have a Schlage Encode™ Smart WiFi Deadbolt or Schlage Sense™ Smart Deadbolt. If you have a Schlage Connect™ Smart Deadbolt, you will need to use one of our partners’ apps like the Nexia or Samsung SmartThings app.
How do I reset my Schlage wireless adapter?
Do so by a) disconnect the battery connector, b) press and hold the outside Schlage button, and while holding the outside Schlage button, reconnect the battery connector, c) make sure that you correctly reset the lock to its factory configuration by pressing the outside Schlage button and then entering one of the two …
How do you clear the code on a Schlage Lock?
To delete a user code on the lock itself, press the Schlage button followed by the programming code, and then hit “2”. After that, enter in the user code that you want to delete twice. If successful, you’ll get a blinking green checkmark and two beeps.
Where is the 6 digit Schlage code?
On the keypad side, or exterior side of the door, you will find a sticker that includes the serial number, six-digit programming code and two pre-programmed four-digit user codes. You must remove the keypad from the door to see the sticker.